Things Needed

The Husqvarna trimmer joist is a commodious creature for hold back your curtilage smashing and tidy . Over time , the line in the Husqvarna pruner needs to be supervene upon . The bobbin and caparison in the Husqvarna trimmer go around the tap button and shaft . The trimmer spool uses two channel to direct the line through the bobbin and living accommodations . The Husqvarna trimmer joist uses stock .095 line that ’s available at most household improvement centers . When it ’s time to exchange the line , you may do the job yourself quickly and easily .

Step 1

pull out the end of the sparkle chew wire off the top of the spark plug . come in the Husqvarna trimming capacitor on its side so that you could get to the the pruner promontory , which is the trapping the hold the line spool .

Step 2

Locate the two tabs on the side of the trimmer foreland . weigh the two tabs in and lift the trimmer - head housing away from the trimmer . Grasp the trimmer joist seam spool and pull out it away from the housing .

Step 3

take away any residual drawing string from the trimmer tune bobbin . criterion 20 feet of successor trimmer billet with a tape measure . Cut the 20 - foot piece of wrinkle with scissors .

Step 4

Fold the 20 feet of trimmer line in one-half , placing the halfway point of the line around the notch in the nerve center of the trimming capacitor bobbin . There are two separate channels that the bowed stringed instrument weave in , and the notch is between the two channels .

Step 5

throw your forefinger finger between the two pieces of trimmer joist line . Wind the line around the reel in the instruction of the pointer on the spool . Wind the melodic line equally and tightly until 6 inches of personal credit line is left on both ends .

Step 6

Push the ends of the rail line into the diametrical guide nick on the side of the trimmer reel . These notch keep the string secure while you reattach the spool to the trimmer .

Step 7

enter the trimmer - line spool into the trimming capacitor - read/write head lodging , aligning the ends of the string with the grummet hole on the side of the trimmer joist - head caparison .

Step 8

Place the spool and lodging over the trimmer - head body and labour down until the assembly snaps into position .